Quote Originally Posted by mackrackit View Post
Can we see you code so we can tell you where the problem is?
Did you code for the data slicer?

http://www.picbasic.co.uk/forum/showthread.php?t=11589

In the meantime look at the tips and tricks section here.
http://davehouston.net/
I will post the code, it's on another laptop I'll fire back up in a little while and post from there. Not much code to it though, just a simple routine to test and be a starting point to learn.

Did I code for the data slicer ? Uh, no, I've made data slicers before from TL 085 op amps before but I don't know about coding for them. I did notice in the data sheet that the RX module has a slicer.

Thanks for the links, not to get OT but I really like your site and bookmarked it ! I packed my last home with X10 stuff, touchscreens controlling TV's and whole house audio through a Smartlinc controller with IR ports, the Smart rocker switches with the vertical row of green LED's, and on and on. I miss that setup, I just have some basic X10 control here now, I still have the controller though.

One more OT thing I thought you might be interested in, I also have the X10 remote pan and tilt modules and the range on the handheld remotes were awful, I added a variable cap in series with a telescoping antenna installed in the remote and the range more than quadrupled and they look factory. They were almost totally useless to me before I added the antennas.

I'll go back to reading your links on this topic though and post back later.THANKS again.

Hi Joe, I think I did try T2400 and still garbled, I'll check it again. BTW: your tachometer program is working great for me, only problem is once you go over ~1000 RPM I have to divide the readout by half but that's not a problem since I don't need to run the machine over 1000 RPM anyway. I checked it with a handheld laser tach.

Man, I keep getting off my own topic here,

Thanks guys, later.