Pic18F14K50 when?

[Darrel Taylor]

Perhaps you are unaware that the Pic18F14K50 is a USB chip

So USB has been available since 2.60 on the 14K50?

To save you the trouble answering its not.

Actually, the answer is YES!
In version 2.60, USB on the 14K50 works just fine. Already tested it.

Those chips only have 1 bank of USB memory at 0x200 instead of several banks at 0x400 like the 2550/4550. So be sure that the other compiler you are using supports USB on the 14K50, because it's different.

Looking at the email sent when my copy of 2.60 was shipped, it was 7/14/09.
I'd say that's "mid July".
<br>

[mackrackit]

Mid July....
I need to get out more ....
Where did everyone SSS hear about it?

[Darrel Taylor]

Mid July....
I need to get out more ....
Where did everyone SSS hear about it?

You had at least heard the rumors by July 12.
http://www.picbasic.co.uk/forum/show...5807#post75807

At that point, contact your distributor and pre-pay for the next version.
If your distributor does that.
<br>

[mackrackit]

You had at least heard the rumors by July 12.
http://www.picbasic.co.uk/forum/show...5807#post75807

At that point, contact your distributor and pre-pay for the next version.
If your distributor does that.
<br>

YUP, Jeff told me a few months ago that a new version was in the works. Being that I buy directly from Melabs I was checking the web site every so often and never saw it mentioned there. Figured there was no reason to pre-pay if it was going to be awhile yet.

Oh well, it is out now and maybe everyone knows about it..

[Darrel Taylor]

Personally, I think there should be an automatic upgrade option.

When the next version comes out ... ship it to me.
Don't wait for me to hear the news.

Charge my card, whatever ... just give it to me baby!
<br>

[mackrackit]

That would be good.
Maybe they will do that some day.

[Free_Flow]

I'm pleased to hear that it now supports it, every time I looked could not see any info on the updates page that a new version was out.

The compiler I converted the old program too has supported the 14K50 for some months now and I have written several programs already so I know the code is good.

I still have to do some more typing to finish the conversion but the code is smaller so its worth the effort and the 14k50 has different peripherals so the code has to be adapted any case.