IC12F508 with Internal Oscillator and Software Reset

[Archangel]

Thanks for Reply...

1)
What is a " Glow LED"?

Means ON LED with PIC12F508 uC.

2)
Please define what you mean by " reset" pic


Restart from Scratch when power is ON


Karan

To restart"from scratch" would require a power off or MCLR reset, maybe a brownout recovery, but I doubt it. So to reset you can use the mclr pin with a 5k resistor pulling it high and tie one of the other pins set as input to it, to reset just say LOW for that pin and PIC will reset. Other way would involve opening the VDD with a transistor or relay. Glow_LED var GPIO.0
HIGH Glow_LED

Lastly you could put a label at the very beginning of you code and execute a goto label, that will not however reset every register unless you have set every register in code.