Well while we're totally off the topic of the whole forum,
My car has this problem where the engine stutters when it's idling,
and the gear change is slack. I wonder if they are two separate problems or the same thing??
Seriously,
@ Insane, I just got started with Microchip's C30, but since I haven't had to begin a program,
(just modify one), I haven't had to configure chips, and pin outputs, etc.
However, I can see that your while(1) loop turns ports on, and that's all it does.
Nothing ever changes after that.
Have you set up the clock properly? some of the dsPics have a PLL that needs to be configured
even though you've connected the crystal.
Maybe you should start out with a Microchip development board so you can begin with
both hardware and software that you know is correct, and then go about changing things.
Maybe join Microchip's forum:
http://www.microchip.com/forums/tm.a...55678;�
where they have a section that specifically deals with their C30 compiler.
Now about my car.....
Bookmarks