PIC18F4620 , what's wrong with my A/D converter code

[ScaleRobotics]

Hello Porcusoru,

It looks like your code is suffering from a general lack of PicBasic commands. I personally, would throw a lot of the picbasic commands in, and take most of the assembly out. For instance, debug, serout or serout2 should solve the serial problem, and ADCIN pretty much would solve the rest. But your professor may have other ideas.

[Porcusoru]

U were kind of right. I addes this lines and now the b*tch works just fine

CONFIG WDT=OFF; disable watchdog timer
CONFIG MCLRE=ON;
CONFIG DEBUG=ON;
CONFIG LVP = OFF; Low-Voltage programming disabled (necessary for debugging)
CONFIG OSC = INTIO67; (INTO67 was NOT in the 400 page datasheet, i found it somewhere else)