pic telemetry system

[comwarrior]

joe, i don't mind 'hacking people off' when 'experts' post that level of rubbish...
Besides, i doubt it's only two people...
Perhaps you should do a search for me on utube...

Don't worrie about the IR link... I've finally (after over yet another day totally searching) found the datasheet for the IR trancever i'm using... and it has the hardware i asked about allready built in AND it is on the same wavelengh as PC IR comms...

So, we can cross that one off... I found some pic simulation software and it would apear my ADC's are ok... will be playing more with the program, i like it...


Just one left... hmmm, how to measure more than 5 volts...

[Dave]

comwarrior, Use a voltage divider....

Dave Purola,
N8NTA

[Melanie]

Hmmm... I must remember to avoid spending time and effort in providing helpful information for at least the more complex part of your posting... and not answering what would be the obvious for 1st grade students of basic electrictity or physics.

How to get your PIC input to handle more than 5 volts moust have been handled at least a dozen or more times on this forum... the SEARCH facility is a good start - and Joe is correct. For newbies, especially those with attitude, do we really have to regurgitate the same advice over and over again nigh on every month?

Melanie (biting her lip and remaining polite!)