Won't go back to SLEEP after 1st Interrupt

[Darrel Taylor]

First off, do the resistor test. Make sure the meter's working.
Never assume the reading you get is what you are actually testing.

For the "Overwriting previous address contents (2007)" error, see this post ...
http://www.picbasic.co.uk/forum/show...75&postcount=5

I'm not sure what you mean by "decommented it", you should have Commented it.

The idea is to eliminate your code and config's as the problem.
If you still get high current readings with the chip locked in sleep mode, then you need to look at the hardware.
By itself, the chip disables pull-ups, puts all pins in input mode, with all analog channels enabled. Current due to noise will be minimal.
<br>

[Archangel]

John,
add this to your config: _FCMEN_OFF , this disables the fail safe clock monitor, made about 200 micro amp difference here.