This might be considered a huge project for me since the previous one was just randomly blinking LEDs, but I want to investigate it none-the-less.

I would like to see about building a project that would consist of:

three buttons (pressing two of the button changes LED states as well as generates a sound. the third button activates different LEDs and generates a different sound)

PIC (to read the buttons and control the output)

Sound Chip (to contain the different sounds and play back the appropriate one)

VERY small speaker (I want to squeeze this all into a very small Star Trek prop)

Ideally I would use PBC NOT the pro version.

What is the easiest way to get this working? I can sorta see how the PIC would be used for the control aspect. I'm a little unsure of what to use for a sound chip. I know there are, I believe, ISD chips out there that can hold anywhere from 10 seconds to minutes of sound. I figure 10 seconds to hold two sounds is plenty.

Any comments or ideas would be appreciated.

Thanks.

Bart