Well a little bit of experiment with my last hardware : 12f683 , max187 12bit ADC , 4 Mhz Int osc. Servo attached instead of SC working ok (a little bit jerky -but acceptable) BUT when I connect SC it works only once at the begining when you plug the battery in.
So, after a little notice THE OBVIOUS THING CAME IN MY MIND!!

Of course there is a problem meanwhile with the SC , as soon as I 'break' for the first time just to to jump to my motor pre-check routine afterwards SC accepts no pulses at all for a period of time. So when I come back to re-activate the motor last position SC does not arm . It must go to arm procedure first (throttle low) and then it accepts signals!

So, the only way we can go is WITH interrupts just to keep the pulsout routine alive!

So obvious ......