MPXA4115A picbasic code

[ScaleRobotics]

Hi, Scalerobotics

Could you tell us what it shows for some close to another calibrated pressures ( water column i.e.) I'm really curious about this "oversampling method" application ...

And moreover after having carefully read the relevant AN 1152 from Microchip ...

At my location and 14 bits, I get an output of 13255. This calculates to a pressure of 1004.86 mBar, and an altitude of 229.85 feet. I don't have a barometer here, so I can't really give you a side by side comparison on the figures. On the internet, it said a nearby weather barometer read 1014.42. But I think this is more a function of the accuracy of the MPX4115a, and to a bigger extent (since I don't have a calibrated barometer side by side) my altitude. The altitude from my calculations seem very close. I think I am between 250 and 285 feet altitude.

Oversampling is really just a form of averaging. So it can't skew your results. At worst, you could have no noise in your A/D conversion, which would give you a 10 bit result with lots of useless bits to the right. Once I find a 470pf capacitor around here, I plan to test results again. I think this will filter the result a bit too much, and take away some of the needed noise. Here, white noise is our friend.

On a side note, at 16 bits, when you watch the results at first power up, you can really see the effects of the MPX4115a and maybe the PIC12F675 warming up. For about two minutes the values really move!