MPXA4115A picbasic code

[Acetronics2]

All experiments with oversampling or no , with opamp etc worked ok when I connect servo (for throttle) -although a little bit of jerky movement servo works! , but everytime it comes to use SpeedControl it does not arm and this has to do with delays on servo routines.

Hi, Alexandros

Could you explain a bit ??? I must admit I'm not sure what you mean here ... the altitude measurement routine could take too much time ???

did you notice you send the servo signal twice ... just at this moment ...

Alain

[ScaleRobotics]

did you notice you send the servo signal twice ... just at this moment ...
Alain

Hey Alain,

Can you explain more? I have not seen any code from Bitmaniac, did I miss something?

I think Bitmaniac is saying his code works fine with a servo, but when connected to a motor controller, it does not work, and he thinks it is due to the delays used in his routine for servo output.

Thanks,

Walter

[bitmaniac]

Well my friends
I was a bit confusing trying to explain things!
Well see previous post #65 (http://www.picbasic.co.uk/forum/show...3&postcount=65) to see what I mean exactly.

If /when using oversampling method this introduces a delay to my pulsin /pulsout routines (simple pass through) .
I even try omiting meter/feet convertion all together and calculating 200m ALT reach by raw data as it comes from ADC only!