COUNT is not counting again

[Archangel]

I discovered one of DT's posts that explained part of my problem was that I wasn't properly clearing the mismatch. When I did that the On-interrupt for RA3 worked. However, I noticed in the same DT post his statement "Keep in mind that you will get an interrupt on both the Press and Release of the button. You will eventually need to change the interrupt handler to determine which Edge occurred." I am using a momentary switch button that grounds RA3 for this On-interrupt and now I see happening what he was warning about...I get an intterupt on press AND release. However, I don't quite grasp how to modify my interrupt handler "to determine which Edge occurred." Obviously I want the interrupt to respond only to the press and not the release. Is there a way to filter out the release action to prevent the 2nd interrupt?

Page 37 of the data sheet, Option Reg allows you to control rising or falling edge on RA2, you might have to move your ports around a bit . . .

[Bruce]

If your switch grounds the input pin to generate the interrupt, and it returns high when the
switch is released, just wait for the pin to return high before exiting the interrupt.

[jellis00]

By following your suggestion for basically debouncing it works. Thanks for advice!