Come on isn't that just a minor technical difficulty??? I thought I was doing good reading the spec sheet. Table 2 has RC5 as CCP1, I thought that I could get away using RC2,3, and 4 because there was P1B, P1C, and P1D. What would I use RC2, 3, and 4 as if they are labeled as P1B, P1C, and P1D? Does that mean I can use them as HPWM's yet they will share the same pulse width as the CCP1? For my project I need two different PWM's so I would need a chip that has two CCP's?
Thanks
Toby