INT0 Zero Interrupts

[nemesis]

Anybody pick up anything else? I feel really frustrated with this interrupt. I think I will try pulling out everything but that interrupt as Joe suggested. Just hoping that maybe the order or bit is wrong in one of the registers.

[nemesis]

Thanks for your replies Joe S.

I figured out the problem. My ADCON1 should have been:

ADCON1 = %00011111 ' Set all to digital

Thanks Again,
Nemesis

[Gusse]

After INT0 interrupt you are not clearing INT0IF variable. I don't know does it make difference or not, but add

INT0IF = 0

before last ENDIF in INT0 interrupt section.


Also TMR0 comment is not valid. It should be ON

INTCON =  %10110000 ' Global, TMR0 off, INT0 ON

BR,
-Gusse-

[nemesis]

Will do thanks Gussee. Sometimes I am victim of my own cut and paste. Thanks again all.

-Nemesis