1. What device programmer are you using?
A1:meLabs Programmer v3.1 for the bootloader
A2: Microcode Loader for actual Programs v2.0.0.1
2. What version of MicroCode Studio are you using?
A:2.1.0.8
3. Are you making any changes to config fuse settings (other than the defaults in the loader firmware) before programming the loader firmware into your 18F8720?
A:No
4. Are you including DEFINE LOADER_USED 1 & DEFINE OSC in the beginning of your code?
A:Yes
Where is this "Flash program write enabled" setting in microcode loader?
Bookmarks