|
Boooooooo ....
Hi, Kessral
The surprising thing is you have configured GPIO.3 as an output ( trisio.3 = 0 ), and you intend to read it's state ...
Moreover, What is ... very annoying is you directly tie an output to ground or VCC ...
Not so good, yeah ...
hope you didn't fry it ...
always use a series resistor ( 1k ) whan you tie a pin to supply rails ...
Alain
PS : at the next one like this one, your surname will turn into " Casserole" ... lol.
Last edited by Acetronics2; - 6th March 2009 at 15:06.
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
|
I upgraded to v8.15 and same problem still exists.
on the PIC10f series GP3 is input or MCLR only and can never be an output. Default setting for GP3 on TRISIO would be 1, which is MCLR so I would assume that setting it to 0 would make it the only other setting it supports (Input only) maybe I am wrong, but I only placed that in the code after trying other methods.
I do use a resistor (at least 1k but usually much more) to pull GP3 to ground to send in a low, but at that point the chip just draws current as if in normal operation but all output functions cease (as in the LED no longer blinks and no outputs from GP0 exist)
This is telling me that GP3 is never actually getting set to input only but is staying as MCLR.. I have tried in the past to no avail, I am basically starting fresh with it now and hoping for help lol
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks