ICD & PBP && how to get it to work

[jellis00]

One question :
Originally Posted by Bruce
If you're using MCS+ ICD, then you should not be trying to use the standard serial
communicator in MCS+.

Inside the ICD window HSEROUT will display whatever you send in the lower section of
the ICD window. When it lands on an HSEROUT while running the ICD, and small serial
ICD terminal window will automatically pop-up asking for input.


Code:
DEFINE LOADER_USED 1 ' using MCS+ bootloader
DEFINE OSC 20 ' <-- DEFINE your OSC speed. gotta have this for MCS ICD.

MyVar VAR BYTE

Loop2:
HSERIN [MyVar] ' <-- window pops-up waiting for input
HSEROUT ["MyVar = ",DEC MyVar,13,10] '<-- displays input
PAUSE 500
GOTO Loop2I've attached a screen capture of the above running in MCS+ ICD. Tested on an
18F4431.

If you still have trouble try blinking an LED with the ICD just to make sure you have
everything setup properly.

Where did this quote come from since I don't see it in this thread. I would like to go to it and review the referenced image.

[Darrel Taylor]

Where did this quote come from...not in this thread??

Post #5, this thread.