Internal oscillator please help

[timbash]

This is all I have, at this point I was just trying to get the thing to do something in this case the leds on the different ports do switch on and off.

@ Device PWRT_OFF
@ Device MCLR_OFF
@ Device INTRC_OSC
@ Device BOR = 0
@ Device Debug_Off

OSCCON = %01110000
OPTION_REG = %11111111
TRISB = %00101010


loop:

TRISB = %00101010
Pause 1
PortB = 1
TRISB = %11010101
Pause 1
PortB = 1
TRISB = %00101010
Pause 1
goto loop

End

[mister_e]

Indeed there's a problem, the above don't set the proper config fuses.

Try

@   device pic16f819, INTRC_OSC_NOCLKOUT
@   device pic16f819, WDT_OFF
@   device pic16f819, PWRT_ON
@   device pic16f819, MCLR_OFF
@   device pic16f819, BOD_ON
@   device pic16f819, LVP_OFF
@   device pic16f819, DEBUG_OFF

That line you had

@ Device BOR = 0

screw everything up

[Bruce]

You might want DEFINE OSC 8 in there too if you're running at 8MHz VS the default 4MHz.

[timbash]

Well Steve, that seems to have done it Thank You!!! I'm not sure I quite understand it all but I can work it out I'm sure.

Thanks again.

[peterdeco1]

Hi Tim. Maybe this will help you. I believe the following also applys to the 16F88.

'INTERNAL OSCILLATOR VALUES for 16f818/819:
'OSCCON = $00 'for 31.25 khz
'OSCCON = $10 '125khz
'OSCCON = $20 '250khz
'OSCCON = $30 '500khz
'OSCCON = $40 '1mhz
'OSCCON = $50 '2mhz
'OSCCON = $60 '4mhz
'OSCCON = $70 '8mhz
adcon1 = 7 ' set inputs to digital. Using the adcin command will automatically convert the ADC port to 'analog
'OPTION_REG.7=0 ' Switch-ON weak pull-up's on portb
'@ DEVICE MCLR_ON, INTRC_OSC, WDT_ON, LVP_OFF, BOD_OFF, PWRT_ON, PROTECT_ON
'CCPMX_ON THE @ DEVICE LINE ABOVE SETS HPWM OUTPUT TO RB3, CCPMX_OFF (DEFAULT IF NOT 'SPECIFIED) = RB2