LCD 8x2 - SPLC780D controller

[DanPBP]

Hello Guys,

Has anyone tried this LCD controller with LCDout?

Thanks!

Daniel.

[Acetronics2]

Hi,

YES !

Nothing special, just characters table slightly different ... very slightly !

Alain

[DanPBP]

Hello Alain,

I tried the SPLC780D controller, but I couldn't make the 8x2 LCD to work.

But, my code is working fine on a 16F877 with a HD44780 controller (20x2).

DEFINE OSC 20
ADCON1 = 7

DEFINE LCD_DREG PORTD
DEFINE LCD_DBIT 4
DEFINE LCD_RSREG PORTC
DEFINE LCD_RSBIT 6
DEFINE LCD_EREG PORTC
DEFINE LCD_EBIT 7
DEFINE LCD_BITS 4
DEFINE LCD_LINES 2
DEFINE LCD_COMMANDUS 2000
DEFINE LCD_DATAUS 50

Pause 500

LCDOut $fe, 1
LCDOut "Hello Word"

End

Any advice on how to configure this controller is much appreciated.

Thanks!

Daniel.

[Acetronics2]

Hi, Daniel

Could you post your LCD ref. ... I use every day a SPL controlled 2x16 Display instead of a classical 44780 , aboard my EasyPic5 Board.

So, I'd recommand you to check twice your LCD Wiring ... R/W pin grounded ??? Contrast set ???

To the end you could try LCD_COMMANDUS 2500 ... I noted my 2*8 LCDs to be a bit " lazy " ... and they need 2000 at least.

Did you try ... another 2x8 LCD ??? a damaged device is always possible ...

Alain

[DanPBP]

Hi Alain,

Well, I tried 2500 on the LCD_COMMANDUS and it's still not working.

I have a working 16F877 with a 20x2 LCD (HD44780) that works great and I use this for debbuging.

So, I replaced that LCD with the 8x2 LCD (both have pins, so nothing to solder on them) and what it does is the following: first, all the characters on the first line went black and the it clears the screen. But. I'm not seeing the text I'm trying to write.

This is the information I have on this LCD:



Everything should be fine, but I'm missing something.

Thanks!

Daniel.

[Acetronics2]

Hi, Daniel

http://www.fordata.cn/pdf/short/fdcc0802b.pdf

Check the Contrast PIN ... you should have ~ 0.5 v on it ...

Alain