having problems to read a PIC16F877

[vanessa]

hi everyone, i am trying to read a PIC16F877 that is on a general control board which controls an engine. there is also a lattice fpga on this board. the thing is that i am trying to read the program that is on the pic device to modify a few things. but the VDD pin on the connector has been cut, is there any kind of modification that i can do to the circuit to be able to read the pic device? i am using mplab icd 2. the board was given to me like that to recover that code, but because pin 2 is missing, the mplab icd 2 reads a lack of power from the pic device. i have attached the schematic of the programming connector (VCC=24V it powers the entire board, and CR1 is a ceramic resonator) thanks everyone!