pullup and pulldown resistor help

[Archangel]

Hi -

How do you know when to use a pullup or a pulldown resistor?
Know when to use what resistor and then what value is not straight forward to me and trying to figure out a simple way to remember to know which to use.

Thanks -

The logic of true determines which to use, if true = 1 then use pulldown, as the pulldown makes it default to false. If true = 0 then use a pullup, pullup makes 1 default to false.

[studysession]

The logic of true determines which to use, if true = 1 then use pulldown, as the pulldown makes it default to false. If true = 0 then use a pullup, pullup makes 1 default to false.

I think I am following you but want to make sure. Could you expand with an example? THanks

[Archangel]

I think I am following you but want to make sure. Could you expand with an example? THanks

ok

If PortA.1 = 1 THEN ' if logic high = true use pulldown to 
                    'make untrue
Do something here !
else ' false this is where the pulldown does it's work.

If PortA.1 = 0 THEN ' If logic low is true use a pullup to
                    ' make false
 Do something here !Light an LED . . .
else ' False, again this is where pullup does it's job
Your code here . . . Say, turn off the LED

[studysession]

Thanks - That's what I was thinking you were saying before but wanted to be sure. Greatly appreciate it.

Keith