okay, after spending about an hour reading through rentron's articles...I have come to the conclusion that I will need to generate the signal, run that through my IR transceiver and then collect it again at the transceiver in the car. I have three transceiver here that have an in and out for RF communication. I am sure I will not need to encode the data stream, right?
Well, I have two of these:
http://www.mouser.com/search/Product...CYV8QSMg%3D%3D
100+ 12F683 I/P
~6 16F683 I/P
~3 16F616
1 18F2550
~500 tact switches
~3000 ft kynar wire (30 awg)
no oscilloscope
1 voltimeter
and soldering iron and glue
other basics
Soo...I am not sure if this is what all I may need to make an IR link between two chips. I just need your guidance guys in all of this. I will post pictures of it if I finish it
Bookmarks