Please help with code for DS18B20

[astanapane]

ok i will try later this afternoon to blink an led.

Do i need capacitors for the ceramic 4 mhz resonator? I have also used a ceramic with 2 legs resonator at 4 mhz.

In any case i will try to blink an led.

As i mentioned on my previous posts, i have tried also the code from elektor, and works. (i just dont have the right sensor DS1820 which is very old and i dont get the right results. but i have something in the screen at least.

With the code from Mr. Fratello, i dont have anything on the screen. That mean that there is something wrong, either with the hardware or software.

Thank a lot again for your help.

[fratello]

The software it's ok !!! Remove the X-tal (leave pins 15 & 16 free), re-compile the code with added from post #73, check the RV1, check the connection to LCD., check the voltage (5 volts).

[astanapane]

ok thanks a lot fratello,

please give me some time to do it in the afternoon.

I have done something else with a completed different thermostat.

please check for my from an other thermostat with an old ds1621, a friend of mine gave it me i can upload the code if you like. (really sorry for my Greeks at the video, i upload it for the AVCLUB.gr there is a sub forum for flashlights)

The reason i put the video is to see the menu for the thermostat configuration. It is nice to see the configured temp and the real time temp at the same time.

Please check the video at 2:12 for the configuration menu.

[astanapane]

there is something on the display now.

thanks a lot. The problem now is that i dont have the right value for the temp.

It appears a minus value for both INT and EXT sensor.

also the values for the SET POINTs are only in minus values. I think the minus symbol appears on both 75 and -25. I will upload pictures later on.

The values now i have are

INT: -0.06
EXT: -0.06

[fratello]

See post #42 !

[astanapane]

ok,

there is no problem with the DQ link.

there is no bad component DS18B20. I have put two new DS18b20 that are working on a different circuit.

How do i know the DS serial number? Do i need to get the serial number from my DS18b20 and place it to the code?

[astanapane]

Sorry for asking so many things, i just be so close to make it work.

So do i need to read the serial number for each sensor and place it inside the code?

do i need to follow that http://www.picbasic.co.uk/forum/cont...r-nine-of-them?

and then get the serial number from the DS?