New project help rapidfire on 12f683

[thm ov3rkill]

Yes, you can. Think in terms of 2 loops each checking the switch. 1 loop elses into the main loop which loops back into the loop, but if true it goes to loop 2 which loops into itself unless true, effectively giving you an on off toggle.

Hi , Joe
thanks for all your help so forth really appreciate it alot

I have a couple questions

For example if i make that trigger rapidfire can it read the low coming from trigger when its being pulled and rapidfire from the same pin at once i made a little digram It doesent have to be thoe pins just did them because there closer in the digram the trigger joint is the middle one to make the on/of toggle what command would i use sleep or what?? also i was thinking of making the on off switch as a mode select for example..

when I turn the controller on It goes in mode 1 automatically. Then if I hit the tact switch attached to ground and one of the pins on chip it would go in mode 2 and stay on there untill I hit the switch. If the switch is pressed one more time it will turn rapidfire off and if i hit it one more time it would go in mode 1 like it started on also how would I make the modes I would use the if then but I dont know if i can use the same one again. here is the digram for example.

sorry for the messed up words as i do not have a steady hand