Quote Originally Posted by Bruce View Post
Some 18F parts allow you to change config settings at run-time, but I wouldn't advise trying this until you're a bit more familiar with how to set them & what they all do. If you're using a boot-loader, you'll need to know every setting the loader expects, or you may end up doing a lot of loader firmware re-programming. If you search here for modifying config settings on-the-fly you'll find a couple routines showing you how.

You probably have the latest version then.

Easy. Open the loader .HEX file with your programmers software. Change it, save the .HEX file, and re-program the loader into your PIC.

OK. It wasn't shown in the example you posted. Note this won't have anything to do with the WDT or sleep error. Only timing for PBP commands.

If your programmers software doesn't allow you to read a .HEX file and make changes to config settings, then you can re-compile the loader firmware with the free version of C18.

Or I can send you a modified version .HEX file if you need it.

YESSSSS!

With meProg of course you can change such things, of course. I have just used for "so long time" now only the bootloader so I forgot the meProg.

Sleep works and NAP works also even that the manual does not confirm that.

What USB board are you using?
What is USB board (melabs U2?) or what ? or 4550? or...