Hi I have followed the advice on the following thread for cdc for dummies...
http://www.picbasic.co.uk/forum/showthread.php?t=5806
I made sure it complied correcly for a PIC18F2450, and then loaded it onto the PIC
once plugging in the usb, it says that the device malfunctioned and that it could not recognise the device.
Attached is a schematic of the device, except that i am using a PIC18F2450 instead of the one on the schematics, but the pinning is exactly the same.
Also attached is the hex and codes used to load onto the PIC....
Any Help of where to find the issue would be of great help!
Thanks
Bookmarks