Help with a draft of a robóvia rf

[cesar35]

Dear mackrackit is the correct code to do
Thank you

'DEFINE OSC 4
'@__config _XT_OSC & _WDT_ON & _CP_OFF
'symbol trisb = 134
'symbol trisa = 133
'symbol portb = 6
'symbol porta = 5
'low 1
'input 0
'input 2

'start:
'pot 0,50,B0

'pot 2,50,B1
'B0 = B0 * 5
'B1 = B1 * 5
'y:
'if B0 < 100 then yf
'if B0 > 150 then yb

'x:
'if B1 < 100 then xr
'if B1 > 150 then xl
'serout 1,n9600,(5)
'goto start

'yf:
'serout 1,n9600,(2)
'goto start

'yb:
'serout 1,n9600,(1)
'goto start

'xl:
'serout 1,n9600,(3)
'goto start

'xr:
'serout 1,n9600,(4)
'goto start

'end

[mackrackit]

No, you still have not dealt with the variables.

Take a look in the PBP manual about variables and symbols.

[Archangel]

No, you still have not dealt with the variables.

Take a look in the PBP manual about variables and symbols.

Which is to say, you cannot store information in a variable which does not exist. In C you would declare the variable. In PBP you still must set it up first . . . Myvar var byte or MyVar var WORD in other words You Forgot to do this.

[cesar35]

foto picbasic

[mackrackit]

Everything is commented out " ' "

At least it will compile nothing

[cesar35]

Dear mackrackit I'm taking stick.
At picbasic I'm very difficult to understand I'm using the English translator. Could make new code. For me.
I will be grateful.

[mackrackit]

I do not have time to write your code.
But here is some old code you can look at to see how Pic Basic code is written.
It basically is a test code for a POT.
And read the threads I linked you to earlier.

'#####################
'16F877A

DEFINE OSC 20

'####################
'LCD SET UP
DEFINE LCD_DREG     PORTB
define LCD_DBIT     4
DEFINE LCD_RSREG    PORTB
DEFINE LCD_RSBIT    1
DEFINE LCD_EREG     PORTB
DEFINE LCD_EBIT     0
DEFINE LCD_BITS     4
DEFINE LCD_LINES    2
DEFINE LCD_COMMANDUS    2000
DEFINE LCD_DATAUS   50

'#####################
V1		VAR	BYTE
LED	VAR	PORTD.2

PAUSE 1000

RUN:
LCDOUT $FE,1,"POT"
LCDOUT $FE,$C0,DEC V1
PAUSE 100
POT PORTC.7,127,V1
IF V1 < 100 THEN
GOTO LMP1
ELSE 
GOTO LMP2
ENDIF
GOTO RUN

LMP1:
HIGH LED
GOTO RUN

LMP2:
LOW LED
GOTO RUN

END

[cesar35]

Dear mackrackit I am very grateful for pacincia.
more just one more dica.Porque that picbasic Compiler without error. generates the hex normal. more pic does not send the data for the receiver. thank you again ..

[mackrackit]

Sorry, I did not quite understand the last post.

Are you saying that you got the Ruff Bot code to compile but it is not working?

If so post your code that compiles and I will assume you have the hardware exactly as shown on the web page?