Help with a draft of a robóvia rf

[mackrackit]

Is this the first time you have programmed a PIC?

If so, then you need to start by making an LED blink.

[cesar35]

I did several projects in asm. I do not have much practice in picbasic. More
do a very light flashes on facil.em asm.
And my first project in picbasic.que I try fazer.mais not had much success.
You could ajuda.impretada.ficarei me very grateful.
Thank you

[Acetronics2]

start:
0.50 pot, B0

2.50 pot, B1

PBP CAN'T understand that ...

first good reason !!!

Alain

[mackrackit]

I did several projects in asm. I do not have much practice in picbasic. More
do a very light flashes on facil.em asm.
And my first project in picbasic.que I try fazer.mais not had much success.
You could ajuda.impretada.ficarei me very grateful.
Thank you

OK, Lets get familiar with PBP.
First read this thread
http://www.picbasic.co.uk/forum/showthread.php?t=543
It talks about setting the config bits in your code.
Then read this
http://www.picbasic.co.uk/forum/showthread.php?t=561

Being that you have written in ASM I will assume you have MPASM installed.
And I will also assume you are also using Micro Code Studio to write your PBP code in.
In MCS go to view-Compiler Options and make sure the bos "use MPASM" is checked.

Now the beginning of your code will look something this

DEFINE OSC 4
@__config _XT_OSC & _WDT_ON & _CP_OFF

[cesar35]

Dear mackrackit is the correct code to do
Thank you

'DEFINE OSC 4
'@__config _XT_OSC & _WDT_ON & _CP_OFF
'symbol trisb = 134
'symbol trisa = 133
'symbol portb = 6
'symbol porta = 5
'low 1
'input 0
'input 2

'start:
'pot 0,50,B0

'pot 2,50,B1
'B0 = B0 * 5
'B1 = B1 * 5
'y:
'if B0 < 100 then yf
'if B0 > 150 then yb

'x:
'if B1 < 100 then xr
'if B1 > 150 then xl
'serout 1,n9600,(5)
'goto start

'yf:
'serout 1,n9600,(2)
'goto start

'yb:
'serout 1,n9600,(1)
'goto start

'xl:
'serout 1,n9600,(3)
'goto start

'xr:
'serout 1,n9600,(4)
'goto start

'end

[mackrackit]

No, you still have not dealt with the variables.

Take a look in the PBP manual about variables and symbols.

[Archangel]

No, you still have not dealt with the variables.

Take a look in the PBP manual about variables and symbols.

Which is to say, you cannot store information in a variable which does not exist. In C you would declare the variable. In PBP you still must set it up first . . . Myvar var byte or MyVar var WORD in other words You Forgot to do this.

[cesar35]

foto picbasic

[mackrackit]

Everything is commented out " ' "

At least it will compile nothing

[cesar35]

Dear mackrackit I'm taking stick.
At picbasic I'm very difficult to understand I'm using the English translator. Could make new code. For me.
I will be grateful.