confused problem with interrupt in a working program

[illuminator4]

thanx for replying. my pic is pic16f877a @ 4Mhz. about Serout2 in the first program i used it. in the second i tried both serout2 and hserout but with no result!
the snif snif was beacuse i had seen hundreds of views in questions asked later than me. sorry!
About the conditions i want to know when my car that i control with the aboe code hits the wall (with the help of the switch). when it hits the wall i want to receive one number. that is all i ask!

[Archangel]

Betcha it is something to do with wait, also You are aware that hser.* is sent true not inverted. Howz about the other end of the equation (what the car sends), and does it send more than once ? Big also, put a pullup resistor on the herserin line.

[mackrackit]

9600 might be a bit fast for 4MHz. So an adjustment there could be in order.

Let work on the interrupt problem first.
The below code has a push button on PORTB.0. PORTB.0 is pulled LOW with an external 10K.
I have an LED on PORTD.2 for testing with a 470 to the zero rail.
Using SEROUT2 so a level converter (MAX232) is not needed at this time.

See if you can make this work and then we can play with the hardware serial and level converters.

'#####################
'16F877A
DEFINE OSC 20
'####################
@ __config _HS_OSC & _WDT_OFF & _LVP_OFF & _CP_OFF &_BODEN_OFF
I	VAR	BYTE
ON INTERRUPT GOTO MACINT
INTCON = %10010000

LOOP:
HIGH PORTD.2
SEROUT2 PORTC.6,16468,["PUSH ME !!!",10,13]
PAUSE 100
GOTO LOOP

'############################################
DISABLE
MACINT:
IF PORTB.0 = 1 THEN
FOR I = 1 TO 10
HIGH PORTD.2
PAUSE 150
LOW PORTD.2
PAUSE 150
SEROUT2 PORTC.6,16468,["MACKRACKIT",10,13]
NEXT I
ENDIF
INTCON.1 = 0
RESUME
ENABLE
 'THE ABOVE WILL ALSO DEBOUNCE THE SWITCH
'#############################################

[mister_e]

9600 baud run perfect @4MHz with the hardware USART (0.16% error), however may suffer with SEROUT, SEROUT2, in this case DEBUG is recommended if you don't want to use the Hardware USART.