It looks like that on my sim scope. Not as locked in, but my pico-scope doesn't trigger that well either.
Printable View
It looks like that on my sim scope. Not as locked in, but my pico-scope doesn't trigger that well either.
Great, thanks. PM your address and I will get the EasyPIC4 out to you.
Ok, will do. Thank you Rmteo!
This is the sim scope. Now I am just having fun, learning how to do all sorts of new stuff
http://www.youtube.com/watch?v=Eec-lAhN0Po
That was the intent of the contest. Glad that you are having fun.Quote:
Originally Posted by cncmachineguy
Just read the manual. It is available online. :) thanks for the offer.Quote:
If anyone is interested, I have a PDF of the manual (it is too large at 2.5MB to upload)
Quick question, all the pictures show both the GLCD and the LCD in place at different locations on the board, but the manual indicates the LCD plugs into the same pins as the GLCD. Any clarity for that?
The GLCD can only be used in its dedicated slot near the bottom of the board. The LCD can be used in its own slot (in 4-bit or 8-bit mode) near the top-left of the board or in the GLCD slot (only in 8-bit mode).
I am sending the EaspyPIC4 to you today via USPS Priority Mail.
Thank you for a very informative contest and prize rmteo.
And congrats to Bert!
Those scope videos are cool too.
Thank you :)Quote:
Originally Posted by rmteo
And Thank you Robert :)
WHoo Hoo, I have my Prize!! Thank you RMTeo for the contest and the prompt shipment of the prize. :):)