U2 programing

Hi there, Everyone I dont know if this is the correct spot for this query but I hope someone can help.
I reacently purchased a melabs U2 programmer but cnt seem to get it to work.
I select a PIC18F2525 from the pull down menu and fit a new PIC18F2525 into the programmer socket ( checked pin 1 in the correct place).
Then from the program menu select get target information the following error message is displayed 'Target device does not match selected device'

I have tried this with a few different PIC types but the same message appears.
Any Help would be most appreciated.

kind regards John;)

Hi Guys, Sorry about this but I put connected to the wrong header on the Remote Chip holder.

Thanks again and please excuse my supidity.