Set Configuration from code?

Is there a way to write the "meProg - Configuration" settings right in my code? Setting the Osc modes, Watchdog timer, Fail safe, etc - all the stuff that pops up in the Configuation window of the melabs Programmer?

I once tried to do this with DEVICE in the code, but PB didn't like that. I don't think I can write to the Config registers in my code after it's already programmed and running - can I?

I chased this once before and gave up, but now I'm using a big 18F for a project and it's got about 40 different Configs - each time I flash it in development, I have to go manually set them all each time. I'd like to flag it so they're automatically set properly from my code.

??

Thanks!

Quote:

---

Originally Posted by kevj

Is there a way to write the "meProg - Configuration" settings right in my code? Setting the Osc modes, Watchdog timer, Fail safe, etc - all the stuff that pops up in the Configuation window of the melabs Programmer?

I once tried to do this with DEVICE in the code, but PB didn't like that. I don't think I can write to the Config registers in my code after it's already programmed and running - can I?

I chased this once before and gave up, but now I'm using a big 18F for a project and it's got about 40 different Configs - each time I flash it in development, I have to go manually set them all each time. I'd like to flag it so they're automatically set properly from my code.

??

Thanks!

---

http://www.picbasic.co.uk/forum/showthread.php?t=543: :)

Have you read this?
http://www.picbasic.co.uk/forum/showthread.php?t=543

If you want to do it at runtime, check out

http://www.picbasic.co.uk/forum/showthread.php?t=4093

LOL. Thanks guys. That'll do it.