Touchscreen question

I am playing with the Touchscreen and gLCD on the EasyPIC5 and I am getting extra pixels lighting up on the screen when I draw something. They always appear at least an inch below where I have drawn a line.
I was wondering what was causing this, the code is in MikroBasic or I would post it here.

Anyway my question is what would be a good delay for debouncing the drivers? They are currently using delay_ms(2). I am assuming that is what is causing them to appear because they only appear when I lift the pen from the screen.

Any suggestions or other comments. I am going to start porting over to PBP next.

Try something like
for k = 2 to (some higher number)
delay_ms(k)
next k

and print the current delay on the screen.

Should do the trick.

Ted

I had the same problem with a touch pad. The streaking in my case was pen pressure related. I added a "Pen Down" function that would only let the pad draw if the pressure was greater than a preset value. Here is the code in C

Code:

---


int PenDwn (void)
{
                OpenADC(ADC_FOSC_64 & ADC_RIGHT_JUST & ADC_8_TAD,
                ADC_CH0 & ADC_INT_OFF & ADC_REF_VDD_VSS, 11);
                TS_Y1_Output;  //make Y Pins outputs
                TS_Y2_Output;
                TS_X1_Input;  //make X plates inputs
                TS_X2_Input;
                TS_Y1_ON;        //energize Y plates
                TS_Y2_ON;
                SetChanADC(ADC_CH0); //select voltage channel
                Delay10TCYx(200);
                ConvertADC();  //read ACD
                while( BusyADC());               
                PenPressure=(1023 & ReadADC())>>2;
                if (PenPressure > 210)
                        {
                        return (TRUE);  //pen pressure exceeded threshold
                        }
                        else
                        {
                        return (FALSE);
                        }
}

---

Basically energize both plates and read the output from the pad.

It worked well for me

Dave

Think I might have found the answer digging around the MikroE Forums. Possible is floating ADC pins. I have the pullups disconnected as per the manual. I am going to put them back on the ADC pins and see what happens.

DaveC3 -Thanks for the suggestion, but they have something like penDown already in the code and I have played with the value with no luck. Going to rest my eyes tonight and try again tomorrow.

Hi, manwolf,

I think the MKE Touchscreen is a bit "lazy" ... and some quick pen writings cause some surprising pixels ... due to the measuring way.

But I do not remember we were on a MkE nor C Forum, here ...

Why not ask this on the dedicated forum ??? surely more answers !

Alain

Quote:

---

Originally Posted by DaveC3

Ted

---

It is manwolf asking not me.

manwolf, as you were not referring to me did you understand my answer?

Huh?? what? when? where? How? :(

This is very confusing because my name is Ted also, so here I go.

Ted's - tried a wide range of values with no luck, however didn't have to change much for the screen to quit responding alltogether.

DAVE3C- Pendown type check already in the code. Played with the value up and down. caused a minor change bit still throwing extra pixels. Always about an inch below the pin x,y.

Acertronics - Thanks I have been digging around, that is where I came across the post for the floating ADC pins. Had invite to dinner so I haven't had a chance to test it out yet.