Printable View
We have tried to transfer from PIC16F to PIC18F2525. When we evaluated the PIC2525 with code to diaplay something in LCD,we failed:
coded in PICBasic ;
compiled using PBP246+MPLab V8;
The machine code did not work, there is nothing in LCD, but if we programm in ASM directly,it works.
And, if we embeded ASM lines into PicBasic lines,it didn't work either!
We have studied the PBP246 & PIC18F2525 for a long time,but no advance.
Anyone faced this kind of question too before?
Any advice is welcome!
Anyone use pbp246 over PIC2525 ?
Code used in PBP?Quote:
Originally Posted by dragon
For what i remind, PBP2.46 & PIC18F2525 worked for me. As Skimask says, just post your code here.
I know for a fact it works as I have a display board with 3 MAX6957's burning away right now with an 18f2525@ 20Mhz. I migrated from a 16f876 and had a few setup issues with registers but it went reasonably well.
Hope this helps..
Thanks,try once more, if failed I will post the test code.
DEFINE OSC 8
DEFINE LCD_DREG PORTA
DEFINE LCD_DBIT 0
DEFINE LCD_EREG PORTA
DEFINE LCD_EBIT 4
DEFINE LCD_RSREG PORTA
DEFINE LCD_RSBIT 5
DEFINE LCD_BITS 4
DEFINE LCD_LINES 2
DEFINE LCD_COMMANDUS 4000
DEFINE LCD_DATAUS 100
CMCON = 7
ADCON1 = 6
TRISA = %11000000
PAUSE 5000
loop:
Lcdout $fe, 1 ' Clear LCD screen
Lcdout "Hello" ' Display Hello
Pause 1000 ' Wait .5 second
Lcdout $fe, 1 ' Clear LCD screen
Lcdout "World"
Pause 1000 ' Wait .5 second
Goto loop ' Do it forever
End
it doesn't work! please help! thanks
Quote:
Originally Posted by dragon
Then study more you must...Quote:
Originally Posted by dragon
In your case...
Port A, Bit 0-3 = data bits for LCD
Port A, bit 4 = e for LCD
Port A, bit 5 = rs for LCD
ADCON1 = 6
According to the datasheet I've got...
You've set up: ADCON1 = %0000110
Vref+/Vref- on Vdd/Vss...
AN9-AN12 = digital, AN8-AN0 = analog...
Do ya see any important information up there?
Page 224 of Microchip datasheet DS39626D...
CMCON should be defined correct value.
Skimask,Thank you very much for kindly explaination.