Need help getting started- setting the configuration word

Hi, I'm a new to Pic programming and I have some questions reguarding IDE's, PBP, and WRITING to the CONFIG registers.

I've just aquired a PICkit2 Debug Express Programmer and microchip's low pincount demo board with a 16f690. Unfortunately the pickit2 burning software can't change the configuration word directly.

I would like to use INTOSCIO mode on PIC16f690 (use internal oscillater to save 2 pins for other use), thus (besides the OSCCON register) I must set FOSC<2:0> bits of the Configuration word to %100.

I have not found any detailed coding information on setting the Config word, and would be greatful for any advice or links to good information.
In particular i am wondering if there are any defines or includes that I should know of, or if the config word can be set directly in hex or binary using assembly or pbp.

I'm not sure if its relevant to my problem, but I am currently testing Microcode Studio as the IDE...and have not gotten a chance yet to look at MPLAB.

Any help is greatly appreciated....

Nevermind...Somehow I had missed this page.


http://www.melabs.com/support/config_defaults.htm




Anyway, has anyone here installed the Pickit2 programmer in Microcode Studio?

Welcome Michael,
You have come to the right place to learn and share in MeLabs P basic Pro programming. This great forum has a search feature (see button above) and lots of experts, (not me). here is an link to one of your questions:
http://www.picbasic.co.uk/forum/show...iguration+fuse

PICkit2 in Microcode Studio
Go to View/Compile and Programmer Options/Programmer/Edit
Enter: PICkit2v2.exe as the Programmer Filename
Use find automatically
Blank the next entry

Thanks for the swift replies! Both were really useful!