Printable View
I have two sensors to control one rele.
One for volt and one for temperature.
When the temperature (Vout) exceed the limit (P3) turn on the rele
and if the temperature is below the limit turn of the rele.
I want now , if the volt (value2) exceed the limit (P5) turn on the rele
and stay on for forever, but i don't know how
P3 and P5 is the limitCode:If Vout >= P3 then 'Temp
PORTA.0=1
Pause 1000
else
PORTA.0=0
endif
If value2 >= P5 then PORTA.0=1 'Volt
Hi,
How about this:
Once Value2 is bigger than (or equal to) P5 the relay will turn ON and stay ON forever. Otherwise the state of the relay depends on Vout.Code:Relay var PortA.0 'Relay connected to PortA.0
Latch var bit
ON CON 1 'Constant for relay ON
OFF CON 0 'Constant for realy OFF
Latch = 0
Start:
If Value2 >= P5 then Latch = 1 'Remember that Value2 has exceeded limit
If (Vout >= P3) OR (Latch = 1) then 'Relay ON if Vout is over limit OR Value2 is or have been.
Relay = ON
ELSE
Relay = OFF
EndIf
Pause 1000
Goto Start
/Henrik Olsson.
Thank youQuote:
Originally Posted by HenrikOlsson
If i want to add two more value
If value >= P1 then PORTA.0=1
If value1 >= P2 then PORTA.0=1
how to make this;
Hi Savnik,
Looks like a job for select case - see page 129 in . . dare I say . .the manual.
I read the select case in page 129 , but i cann't understand how to write the code , because i have many variablesQuote:
Originally Posted by Joe S.