ISP Pro

Hello All
First time posting on your forum. Well after a very long and patient wait
for an upgrade for another company's complier(no names mentioned)
that never materialized.I took the plunge and purchased PICBasic.

My question is how well does the ISP-Pro work with PICBasic.
Will this work as an In-Circuit-Debugger for PICBasic too?



Thanks in advance for any thoughts about this.
Gordon

Hello again.

Perhaps the question should have been worded as, does anyone here you
the ISP-Pro as thier main programmer? If so how well does it perform?


Gordon

ISP or ICSP is supported by your device programmer.

ICD could be done using the right hardware and/or software. If you want a fair ICD use MicroCode Studio PLUS. It's a really nice code editor, also come with tons of Bootloader firmware, a serial communicator (like Hyperterm but easier to use), AND a ICD.

Have a look @ www.mecanique.co.uk

everything is well explain there.

Steve (Mister e)
The ISP-Pro I'm speaking of is a programmer/ICD made by Basic Micro.
When I looked at supported programmers in MCS, it was listed. To tell
the truth I'm was a little suprized it listed in the IDE for MCS/PBP. This will
be awesome if works with MCS/PBP as an ICD. Gonna give a try, let know
how it works.

Thanks for your reply Steve.
Gordon