Printable View
Out of the ether, my mplab seems to have developed a probem.
the format of the file *.cod cannot be read or written its extension is not recognised
where * is my file path C:\....
Contacted melabs and they just said buy new compiler !
my current verison of mplab is 7.0
picpro is 2.43
It has been working fine now I do not seem to be able to generate the code in memory although the asm file seems fine.
Why are you using MPLAB? If it's just to write your code then compile, you may try MicroCode Studio. There's a free version available on the following link
http://www.rentron.com/mcstudio/mcs2300.zip
I hope this will work... Of course an update will be a smart choice. I'm just surprised about the MELABS's answer :(
You can still use the usual, remove everything, and reinstall everything + the MPLAB plug-in
I seem to remember MPLAB having huge problems with long file names up until very recently. Go grab the very latest free copy from Microchip.
I have made MPLAB compile with PBP sucessfully, and usually use the .cod file in my work too. Sorry, been a while since I set it up so I don't remember the secisics, just that it does indeed work.
Be advised, MCS may be a better authoring environment, as it highlights and jumps to problem lines (well.... sometimes, but that's another issue).