How to use a 20 MHz resonator on a 16F688

Question: what are the settings to fire up a 20 MHz resonator instead of the onboard clock?

right now I have the OSCCON = &70 for 8 Mhz but am missing the documentation where there is a 20 MHZ switch?

thanks for andy help.

PS how would you verify a 20 MHz operation being functional. which pin to verify with ocilloscope. thanks

Define Osc 20

Quote:

Originally Posted by Thomas Williams

PS how would you verify a 20 MHz operation being functional. which pin to verify with ocilloscope. thanks

Hi,

With the code below you should see the light of the LED 60 times in 1 minute.
Just count and check your watch. (The LED is ON for 500 ms and OFF for 500 ms).

Remember to add to your code "Define Osc 20" and set as output the pin where the LED is connected.

Best regards,

Luciano

Code:

Low PORTB.0 ' Turn off LED connected to PORTB.0 loop: Toggle PORTB.0 ' Toggle the LED connected to PORTB.0 Pause 500 ' Delay for 500 milliseconds Goto loop ' Go back to loop and blink LED forever End

Example with LED. (Your board will have a different oscillator).
http://img8.picsplace.to/img8/3/pic_led.jpg