Printable View
Hi Picers
I've got a RFID Reader module. When connected to the Serial port of my PC, at baud rate of 9600 bps, it is working perfectly and sends me the ID Number of the RFID Tag, when scanned.
What command must I use in picbasic to receive the RFID from this Module?
Sorry to tell you that but, did you read the PBP manual, datasheet and forum's thread before posting your question???
HSERIN,
SERIN,
DEBUGIN
could be use for that.
Steve
Yes, I have read it, and have tried it, but not one of them worked.
The only thing I get back is character 255???
did you tried inverted mode with Serin?
did you try to receive/send data from/to your PC with your PIC to test?
Hi Steve
I can send and receive data to the PC?
But with the PC I use the Serin where I wait for a certain character and take the next one, but with the RF Module it is not possible, because it only sends me the ID I have scan?.
I will try inverted, and see if that works.
what kind of rfid reader are you using?
The ID12 hybrid short range RFID reader module