using pbp pro with mplab and pickit2

I have hooked up all of the equipment and am able to program and run on the labx1 board. I want to use the pickit2 to debug and single step.

When i try to do this, it single steps but does not go to the source to tell me what line is being executed. How do i setup it all up? I am using this demo prog with the debug.bas file.

' PicBasic Pro program to blink an LED connected to PORTD.0 about once a second

LED var PORTD.0 ' Alias PORTD.0 to LED

Include "debugmon.bas"

debugflags.0 = 1 ' Start in debug monitor

loopX: High LED ' Turn on LED connected to PORTD.0
Pause 500 ' Delay for .5 seconds

Low LED ' Turn off LED connected to PORTD.0
Pause 500 ' Delay for .5 seconds

Goto loopX ' Go back to loop and blink LED forever
End

Hi,

Try this thread http://www.picbasic.co.uk/forum/showthread.php?t=8382, especially Bruce's explanation of what's going on.

Regards,

Anand