LCD Blink

Hello i need help...

how i avoid the blink using serout

example:
SerOut 1,N2400,[254,1]
pause 100
SerOut 1, N2400, [254, CDLine1,"EGT=",#EGT]
Or
SerOut 1, N2400, [254, CDLine1," "]
SerOut 1, N2400, [254, CDLine1,"EGT=",#EGT]

jetpr

I think you need to tell us a bit mor precise what actual problem is.

I understand you are using a serial LCD.

is the "blink" you are talking about a "blinking-block-cursor"

What type of display are you using?

In set of using Clear the Screen with the LCD command ...

Who i ken clear the Screen with out the LCD command for clear to avoid the blink screen..

my problems is when you print to the LCD example...
Start:

Run=125
SerOut 1, N2400, [254, LCDLine1,"Run=",#Run]

Display Run=125

but the problem is

Run=12
SerOut 1, N2400, [254, LCDLine1,"Run=",#Run]

Display Run=125

goto Stat

the number 5 is from the one before and if a use the clear command then you si the screen blink..
this ken be done by send spaces but i look blink and with the command for lcd...


my ingles is not good so i dot now is a explain correct...

I appreciation the help ..

ayeeeeee. O.K.

I'll try to make your life easier with some question and answer

1. Do you want to avoid LCD blink when you refresh your display?

This can be caused by the slow baudrate you're using or the delay between each LCD refresh.

Usually when using a PAUSE of 100 ms between each LCD refresh is good.

Try this

Code:

---


start :

    SerOut 1, N2400, [254,1,"EGT=",#EGT] ' this line clear the LCD
                                          ' and display on the
                                          ' first line in one shot
    pause 100
    goto start

---

2. Do you want to refresh only one part of your display. I mean only the section after "EGT=" ?

In your case, try this one

Code:

---

SerOut 1, N2400, [254,1,"EGT="]
start :

    SerOut 1, N2400, [254,$84,"    "] ' this line clear 5 character
                                        ' after "EGT="
                                        '
    SerOut 1, N2400, [254,$84,#EGT]    ' this line display your result
                                        ' right after "EGT="
    pause 100
    goto start

---

I hope this is what you're looking for.

I'm i right but you speak spanish? If yes, let us know, i think that some user can translate for you.

WHO'S SPANISH HERE???

P.S: a i see you just edit your post, perhaps the 2nd code example will work.

Thans for you help i fix it

Great to know that jetpr!