16F684 - Capture - Timing - Counting

I have done a bit with interrupts, but am new to the CCP feature. I am looking to use "capture" to measure a shaft revolution time. In addition, I need to count the shaft revolutions (1 pulse per rev) . Does the capture trigger an interrupt of some kind where I could increment a value to count the revolutions? I am looking for some direction. I intend to get the time capture going first, then add the counter if it is possible for both to be done. Thanks much for any input. Scott

This application note from the microchip site will help you get started

http://ww1.microchip.com/downloads/e...tes/00594B.PDF

and you must apply those notes with respect to the device you are using by referencing the specific datasheet.

have fun




...