Printable View
OK, this is mainly for fun but I'm trying to setup a serial LCD using a standard 16x2 LCD panel and a 16F84A.
Only problem is I just can't get it working properly.
Has anyone done this before and has some code I can scan over?
Like I said, I'm just doing this to learn some more about the PIC's and serial communication so it's not a desperate measure to get an all singing all dancing one :)
Cheers
Leigh
What you know about your LCD ? Baudrate, command... tell us the exact things you have on hand.
I'll consider that your serial LCD is a 2400 baud, drive true, and accept common command.
Serpin VAR PORTB.0
TRISB.0=0
Serpin=0
pause 1000 'waiting for lcd startup
Serout serpin,0,[$fe,1,"hello",13,10]
here : goto here
But maybe you want to do a kinda serial backpack too...
Code:' Serial LCD 2400 BAUD
SerData VAR byte
SerPin VAR PORTB.0
TRISB.0=1
LCDOut $FE,1 'Clear LCD
Start:
SERIN SerPin,0,SerData 'receive data
LCDOut Serdata ' Send to LCD
GOTO Start
Yep, serial backpack is what I'm attempting to do.
I've essentially got what you've put in your example, but it just doesn't receive the data effectively enough at all and tends to fill the screen up with garbage.
I'm sure there's got to be a better way to keep things in sync, but at the mo I can't see it!!
Depending on wich baudrate you perform it too. Is it doing the same garbage stuff on 2400 bauds? If you're using PIC to Send data to the PIC may try to add
DEFINE CHAR_PACING 1000
and post what happen. If you're using Hyperter, Microcode studio, be sure of the polarity of your SERIN ... i.e True/inverted.
Case you use Hyperterm you must set SERIN inverted if you're not using any RS-232 inverter (Like MAX232) .
example for 2400 BAUD
SERIN Serpin,4,SerData 'receive data from PC inverted
with this, be sure of your resistor between PIC and PC. Work good between 1K and 10K.
Surely for 2400 Inverted the Serin mode should be 396 right?
Or am I barking up the wrong tree??
Ignore me - that's for Serin2 - DOH!!
Hehe, that's happen !!! for serin2 :16780
OK so that kind of works ok now.
Just need to figure out a way of telling it if there's no valid serial data coming in then just sit tight and wait...
I guess adding a flow pin might help eh??
for sure you can use a flow pin, but most serial LCD backpack on the market doesn't have those... you can simply check the SerData range. In all backpack i did, i've never use this kind of flow control... but if you feel safer with that issue...
I don't really think it'll be an issue, but it just seems that if the port isn't connected to anything it just spurts garbage out everywhere.
Other than that it seems to be working lovely now!
easiest way... pull-down resistor (let's say 22k) to ground.Quote:
I don't really think it'll be an issue, but it just seems that if the port isn't connected to anything it just spurts garbage out everywhere
That way if your lcd it's not connected... he will see only 0'S
Well, that's another project sorted - works lovely now!
Thanks for all your help there Steve.
Next one in line is interfacing data output using a serial inverter or similar to datalogging software on a PC.
But that's later... ;)
If you have a Palm PDA, you can go wireless with SirPic's simple plug and play interface, and data logging software....
htttp://www.sirpic.com