The output is pretty clean in my experience. I use my photodiode in photoconductive mode (reverse bias), which makes it faster and supposedly noisier but I haven't noticed any noise except in some...
Yep, that did it! The output is now as smooth as the 16F883's output. The 16F883 used the INT_INT interrupt from the start. The GPC_INT requires the particulars you noted, and additionally it...
How clean is the output from your photodiode?
I have been working on a similar setup recently using an encoder wheel and photointerrupter.
I had greater success feeding the MCU's input...
I had thought - should I be using "INT_INT" instead of "GPC_INT"? It is set up using GPIO.2 as the interrupt pin, which is the dedicated INT pin per the datasheet. Can you set up an interrupt on...
I have a project using three 12F683s controlled by a 16F883 master. The goal of the project is to track the RPM of 4 independant propellers on a quadcopter using an IR photodiode and emitter (i.e. a...
Menu
Re: Error compiling with DT Interrupts
Hi Richard,
PaulMaker Today, 23:18thank you so much for your quick reply.
And once again you are 100% correct.
How could i be so blind?
Thanks. It now compiles correctly.