.. yes the 'AO3400A' are good for what you want, and the very low '0n resistance' means most all the voltage will be on the coil, which is what you want. The only thing about the SSR's is that the...
Very interesting, I wasn't aware of these puppies. I have 5V 100mA mechanical relays similar to these:
https://partsource.ca/cdn/shop/products/r3154_front_1800x1800.jpg?v=1686674311
they have these things..... SSR (solid state relay) 4 pin dip..... >1 amp, 60 v...... this is at Digikey but should be able to get most anywhere
.
9981
My requirements:
- can easily handle 800mA at 9V (to drive a solenoid),
- will be used in single bursts, not continuously,
- can be triggered using 5V signal,
- low cost,
- small footprint (as...
data sheet said 5v solenoid is about .7 amps.... 700 ma, and that opto thing data said 30 ma continous..... need a better driver ckt, can use a transistor or a DIP ss relay good for up to 1 amp
Menu
Re: New project - MSFS C++ USB interface
One of the challenges I had given myself was to simulate an electric breaker in MSFS, just like the ones in a Cessna 152.
Demon Today, 02:459983
So far, the least expensive and "good enough" technique was...