if you don't try you will never know
richard Today, 06:39i have zero experience with zcd module but reading the blurb it seems to bias the pin to about 0.7 ish volts. the signal is applied through a suitable R, so that when the signal goes negative the...
richard Today, 06:35Thanks Richard,
I had actually read Romans article but, thankfully, my signal never shows two simultanouse tones - it's always one or the other which makes it easier.
I started with ZCD module...
I don'know - author on the link above used timer3.
I guess, mechanically changing it to timer1 or 2 won't work, since there's some ASM code involved...
why timer3 ?
any timer that can provide a 10mS interrupt could be employed, the self configuring aspect of the code will not function for modern pic chips. the code will need a tickle to adapt it...
not to be unexpected, the LCD timing defines need to match the display in use. some are very slow
I just did not understood what all these ff's at the end of the code do.
not pretty I...
Great work Richard!
Works very well. Thank you.
I had to change LCD_COMMANDUS to 2000 from 1500 for best performance.
I just did not understood what all these ff's at the end of the code do....
No MIBAM this time :)
I tried to use original files, but they got that error, then I found this post:
...
removed debug messages that are sent before spbrg set to correct value
since 1827 has more resources have increased buffer size, u may not need pacing any longer to compensate for
the 4 bit lcd...
Re: FSK demodulator in firmware
Yeah, never used ZCD before either, looked to be the perfect solution for this and a good excuse to play with it.
HenrikOlsson Today, 08:43Problem with the ZCD and my signal is that the bus idles at 35VDC for "long"...