Before dealing with the registers directly, does anyone know what is the sequence, if any, on the analog inputs of the above chip?
I mean, after RA0-RA7 that corrssponds to Analog 0 to Analog 7,...
Plus to what Henrik posted, if you want Pickit2/Pickit3 standalone software, there is also a (paid) version of the old stand alone but now developed and supported by Anobium...
Ioannis Today, 14:04Strange ...
What IDE do you use and which PBP version ???
here, I tested with MPLAB 8.92 and PBP 3.1.6.4 ( last release )
Thanks for the help, however i still can't compile. i just want a HEX. i hope someone can post it. thanks
Galaxy76 Yesterday, 18:19also you can download this one ...
https://support.melabs.com/articles/6151-meconfig
Pretty useful, no ?
Hi,
Replace your @DEVICE ... lines by
;----[12F629 Hardware Configuration]--------------------------------------------
#IF __PROCESSOR__ = "12F629"
#DEFINE MCU_FOUND 1
#CONFIG
Hello, I have this code, but I can't compile it. I always get error. Could someone please compile it and post the hex file here? Thanks
sorry for my english.
@ DEVICE pic12F629,...
Yes, all the time and most times in conjuction with DT-Ints for PBP context save/restore. For periodic/cyclic interrupts using TMR2 (or one of the same type) is nice because you set it up once and...
HenrikOlsson - 22nd May 2025, 15:27
Re: Analog inputs on K42 chip
Managed to test it and yes. One can count from 0 up to the last port in series for the analog inputs.
Ioannis Today, 14:18Works just fine.
Ioannis