Well the carpet is one thing. Even if you just walked the room and returned back to you chair (even worse if it has suspension), then you may well have charged enough to destroy the chips.
You...
you may well have but if you think every pic chip is the same then you will be in for a world of hurt . read the data sheet
richard Today, 04:28not really , why would you want to change it back and forth?
is there a pullup for the tx line ?
post entire code snippets are nil value
Like this on a 16F18877?
ODCONC.6 = 0 ' Permit transmission (source current at will)
hserout [ ...message... ]
while TXSTA.1 = 0 ...
I've worked with the BMP180 with PBP, but not the BME280 IIRC.
Troy
Yeah, had Port instead of Lat.
https://www.picbasic.co.uk/forum/showthread.php/26614-Leaves-the-mainloop
I switched this to WDTE=OFF and it no longer resets.
(have some reading to do on...
PIC 16F18877
#CONFIG
__config _CONFIG1, _FEXTOSC_OFF & _RSTOSC_HFINT32 & _CLKOUTEN_OFF & _CSWEN_OFF & _FCMEN_ON
__config _CONFIG2, _MCLRE_ON & _PWRTE_OFF & _LPBOREN_OFF & _BOREN_ON &...
I "like" the 16F1937, but I have no allegiance towards it (I only have 15 on hand, I'll keep them for "something else"). :D I'm starting the slow/annoying process of choosing another PIC, with...
Demon Yesterday, 17:55Since the output on that specific chip will remain as driven output, and if you insist on using this, a crapy solution maybe to add a diode at the output before the pin is connected to the bus.
...
Re: SOLVED - PIC seems to RESET unless I add a PAUSE in Mainloop
Normally Watchdog is reset within the code PBP produces.
Ioannis Today, 14:00But why it does not in the case of 16F18877 seems strange. Maybe it is not controlled correctly?
Ioannis