I conect ICSP directly to pins. And from konektor, other part of circuit connect via 2K resistor. If you use pin as inputs, then other hardver driving state of pin. So not to have colision with...
I wouldn't do that. Your safest bet would be to have a jumper you can remove to isolate the output of the HC14 from the PGC/PGD pin while you're programming.
Not sure how I would have and looking at that register even any value 0's or 1's, it would still work??
Considering the application doesn't require any precise timing, should I provide a...
sounds like you have over written the osccal/ value stored at the top of memory for 12f508.
Most programmers will not reprog that chip when the value is missing.
The old pickit2 can reset a value...
its very easy to do.
on a pic curiosity board the pins are just there begging you to use them. you can kinda forget the programmer is on board
when there is no need to plug and unplug it at all....
Published on - 27th May 2010 02:01
Number of Views: 8789
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
Re: PBP and IDE/programmer
are your cable longer than 15-20 cm?
Ioannis Today, 15:02Ioanins